Laboratorio 2: Simulación de Subredes

 

Hola este es el video del laboratorio #2 Simulación de subredes.

Estos son los comandos de router y switch que usamos en este lab.

Router(config)#

Router(config)#

Router(config)#interface Serial0/0

Router(config-if)#ip address _IP_ _MASK_

Router(config-if)#

Router(config-if)#

Router(config-if)#exit

Router(config)#interface FastEthernet0/0

Router(config-if)#ip address _IP_ _MASK_

Router(config-if)#duplex full

Router(config-if)#

Router(config-if)#exit

Router(config)#interface FastEthernet1/1

Router(config-if)#ip address _IP_ _MASK_

Router(config-if)#duplex full

Router(config-if)#

Router(config-if)#end

Router#configure terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#hostname R1

R1(config)#

R1(config)#end

R1#copy running-config startup-config

Destination filename [startup-config]? 

Building configuration...

[OK]

R1#

S1#

S1#config t

Enter configuration commands, one per line.  End with CNTL/Z.

S1(config)#vlan 99

S1(config-vlan)#exit

S1(config)#interface vlan99

S1(config-if)#

S1(config-if)#ip address [_IP_] [_Mask_]

S1(config-if)#no shutdown

S1(config-if)#exit

S1(config)#interface range fa0/1 - 24

S1(config-if-range)#switchport access vlan 99

S1(config-if-range)#

%LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan99, changed state to up

S1(config-if-range)#exit

S1(config)#ip default-gateway 192.168.100.1

S1(config)#exit

S1#

VERIFICA!!!

S1#show interface vlan99

ENRUTAMIENTO ESTÁTICO!!

R1(config)#ip route [_Network_] [_Mask_] [_Next_Hop_]